The Table of Contents for this section is available.
The work covered by this section consists of furnishing, installing, relocating, maintaining, and removing cones and reflective cone collars in accordance with the plans and specifications.
All materials shall meet the requirements of Division 10 shown below:
Cones Article 1089-3
The provisions of Article 11053 will be applicable to the work covered by this section.
Cones used at night shall have reflective cone collars as shown in the plans. All cone collars installed at any one time during the life of the project shall utilize the same type of reflective sheeting, unless otherwise approved by the Engineer.
All maintenance shall meet the requirements of Article 11054. Any cone or reflective collar that becomes torn, crushed, discolored, or otherwise damaged such that it will not perform its intended purpose shall be immediately replaced by the Contractor.
The quantity of cones to be paid for will be the maximum number of cones acceptably placed and in use at any one time during the life of the project.
The quantity of cones, measured as provided in Article 11355, will be paid for at the contract unit price each for "Cones". Such price and payment will be full compensation for all work covered by this section, including but not limited to furnishing, installing, maintaining, relocating and removing cones.
Payment will be made under:
Cones Each